Sản phẩm được nhập khẩu chính hãng từ DFRobot
Hỗ trợ kỹ thuật trong quá trình sử dụng
Xuất hóa đơn VAT cho cá nhân, đơn vị có nhu cầu
Sản phẩm được bảo hành 3 tháng
This full-scale oxygen sensor employs the original AO2 CiTiceL® oxygen sensor probe and features a measurement range of 0-100%Vol and I2C digital output, which can be adapted to application scenarios including oxygen generators, automobile exhaust, and air-fuel ratio detection.
The DFRobot oxygen sensor has a built-in calibration algorithm on the signal board that can quickly perform single-point or double-point calibration so as to accurately measure the oxygen concentration in the environment. Based on the principle of electrochemistry, the sensor probe comes with strong anti-interference ability, high stability and sensitivity, and up to two years of service life. It is compatible with mainstream controllers such as Arduino, ESP32, Raspberry Pi, etc. Besides, the sensor is designed with an easy-to-use Gravity interface, and with our sample codes, you can quickly build an oxygen detector.
Caution: Exposure to high concentrations of solvent vapors is avoided, both during storage, fitting into instruments, and operation.
Caution: After a long time of sealing storage, when unscrew the sealing cap on the probe, it needs to stand in the air for at least 3 minutes after unscrewing the sealing cap to preheat the sensor.
+ Strong anti-interference ability
+ High stability and sensitivity
+ Oxygen generators
+ Automobile exhaust
+ Air-fuel ratio detection
+ Physical Quantity Detected: Oxygen concentration
+ Measuring Range: 0~100%
+ Working Voltage: 3.3～5.5V DC
+ Output Signal: I2C
+ Working Pressure Range: 0.5~2.0Bar
+ Operating Temperature Range: -20°C ~ +50°C
+ Operating Humidity Range: 0-99% RH (non-condensing)
+ Response Time: ＜5S
+ Lifespan: ＞2 years (in air)
+ Size: 32mm*27mm/1.26*1.06 inch
+ Mounting Hole Size: inner diameter 3.1mm(0.12 inch)/outer diameter 6mm(0.24 inch)
+ Compatible with Arduino, ESP32, Raspberry Pi